Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is made exclusively to the little lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has become broadly utilized inside the market of logistic devices for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed through the solenoid valve with the speed managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Standard Description
This energy unit is developed solely to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve along with the velocity managed by the adjustable needle valve. When the lift rises to a higher positoin, however the energy supply is cut, the reducing motion is managed from the manual override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This power unit is built exclusively for your massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and the speed managed by a strain compensated movement handle valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This power unit is developed exclusively to the substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as the velocity controlled from the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is lower, the lowering movement is managed by the guide override function.
Specific Notes
one. This energy unit is of S3 duty cycle, which could only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned prior to installation of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which should also be clean and totally free of impurities.N46 hydraulic oil is advised.
4. Oil shifting is required after the first one hundred operation hours,afterwards as soon as every single 3000 hrs.
five. The power unit shown is made to be mounted vertically.